RV
Services in St. Helens, oregon

Generators often show trouble after long idle periods, then a sudden hard run when you need them most. We see starting problems, unstable output, and shutdowns that only happen once the generator warms up or takes a real load.

We run diagnostics in real operating conditions, confirm fuel delivery and ignition behavior, then correct the failure that is causing the instability.

When an inverter acts up, the inverter is not always the only problem. Battery condition, charging input, cable sizing, and grounding all affect inverter performance.

Our technicians test the inverter as part of the full power setup, so you do not end up with a repaired inverter that still shuts down because the root issue stayed in place.

AC issues usually show up as weak cooling, short cycling, or a unit that runs but never catches up. We check airflow restrictions, electrical supply, capacitors, controls, and the parts that typically fail under heat stress. If the problem comes from power delivery or a failing component, we correct it so the unit runs consistently instead of cutting out at the worst time.

Refrigerators fail slowly first. Cooling becomes uneven, temperatures swing, or the unit struggles after a travel day. We inspect operation, ignition and controls when applicable, airflow around the unit, and power stability. Then we repair what is keeping it from holding temperature reliably, because a refrigerator that “mostly works” still ruins a trip.

Slide motors can fail, but we often find that the motor is reacting to resistance from alignment problems, worn components, or binding in the mechanism. We inspect movement, confirm what is causing the load, then repair the motor or the mechanical issue that is forcing it to work too hard.

A seal problem is not just a cosmetic issue. Once water gets in around a slide, it can travel into flooring, wall material, and trim before you spot it. At OGRVs, we repair or replace seals and check the contact points so the seal actually does its job instead of looking good while still letting moisture through.

Roof leaks often come from small openings that go unnoticed during quick inspections. We trace water paths, inspect seams, penetrations, and mounting points, and confirm where intrusion actually begins. Repairs target the real entry point so moisture does not continue spreading beneath the roof surface or into interior materials.

Sealing and coating only work when applied to a roof that is properly prepared. We address failed seams, aging sealant, and vulnerable areas first, then apply products suited to the roof material and exposure history so protection is restored without trapping moisture or hiding unresolved problems.

Plumbing problems often appear as pressure changes, cycling pumps, or damp storage areas. We test systems under use, inspect supply lines, fittings, valves, and drains, and identify the failure point. Repairs restore stable operation so the system holds up during travel and regular hookups.

Window fogging, drafts, or staining signal seal failure and moisture entry. We inspect window frames, seals, and mounting points, then correct fit and sealing issues. Repairs restore proper weather protection and help prevent interior damage that spreads behind walls and trim.

Winterization protects plumbing and vulnerable systems from freeze damage and deterioration during storage. We drain and protect water lines, fixtures, and components while checking areas that commonly fail during downtime. This reduces damage that often appears when systems are restarted.